Zoeller 292-0001 M292 Waste-Mate Sewage Pump

Single and double seal submersible sewage or dewatering pumps

• Durable cast iron constructed switch case, base, motor and pump housing
• No sheet metal parts to rust or corrode
• All cast iron class 25-30 25000# tensile strength
• Stainless steel screws, bolts, float rod, handle, guard, arm and seal assembly
• Oil-filled, hermetically sealed, automatic reset thermal overload protected (1 Ph only) motor
• Maximum temperature for sewage or dewatering 130°F (54°C), 120°F (49°C) for WD295
• If over 130°F (54°C), consult factory
• Shaft seal - stainless steel carbon & ceramic rotary
• Corrosion resistant powder coated epoxy finish
• Upper sleeve bearing and lower ball bearing running in bath of oil
• Neoprene square ring & gasket
• All models pass 2” spherical solids
• Major width (single seal): 12 7/8"
• Major height (single seal): 18 9/16"
• Automatic units available with float operated, submersible (NEMA 6)2-pole mechanical switch
• On point: 14 ¾”
• Off point: 5”
• Specify 2” or 3” NPT female flanged vertical discharge
• 100% computerized tested
• WD295 controlled by variable level float switch
• Automatic units available in single phase 292, 293, 294 & 295 series

Models 4292, 4293, 4294, 4295 Double Seal Pumps (non-automatic only):

• Gives motor extra protection from seal leaks
• Improved bearing lubrication
• Helps eliminate seal and bearing damage from dry runs
• Major width: 12 7/8"
• Major height: 21 3/16"

?