Centrotherm ISELS0345 3" x 45 Elbow With Long Socket

This elbow allows to make a 45-degree turn when installing 3" Innoflue SW (Single Wall) vent pipe and fittings. UV-rated (can be used indoors and outdoors). Note: IANS03 (3") connector ring is required on all 3" Innoflue SW connections and is sold separately. IACE50 Centrocerin lubricant recommended for all gasketed connections.

• Innoflue SW (Single Wall) is the only polymer vent system on the market listed to UL 1738
• Accepted and approved by over 50 North Amercian manufacturers of boilers, water heaters and furnaces
• Suitable for natural gas, propane and fuel-oil condensing and non-condensing (flue temp. below 248°F) appliances
• All parts (pipe, fittings, etc. - both black and grey) are UV resistant and suitable for indoor or outdoor installation
• Requires no primer/glue and does not leach chloride like PVC & CPVC
• Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles
• Industry-leading 2mm wall thickness
• Built-in gasket allows for adhesive-free installation which can be adjusted at any time
• May be installed through a wall, chimney, chase or between joists
• Lightweight, requires minimal support
• Made in the USA from environmentally-friendly PolyPropylene (PP).