Burnham X-209N-TH, X-2, 280 Input MBtu, 84% AFUE, LWCO Integrated in Natural Gas Water Boiler, Chimney Vent, Limited Lifetime Warranty with Taco 007e Pump (Altitude up to 10,000 feet),

• 84% AFUE
• 38 – 280 MBH (8 sizes)
• Advanced controls, accessible inside boiler jacket
• Integrated boiler control with diagnositcs
• FREE additional pump relay
• Integral LWCO option requires no piping! (IDL-1200)
• Industry standard tapping locations allow easy, direct replacement for thousands of existing boiler installations
• American-made cast iron heat exchanger
• d to promote turbulent water flow within the section for efficient heat transfer
• A solid, reliable, full-featured boiler at a value price!
• Lifetime limited warranty
• Made in Lancaster, PA, USA

Standard Equipment

• Intelligent Hydronic Control; simple self-diagnostic control system with 3-digit readout for status settings and errors
• Pre-installed IDL-1200 integral LWCO with auto reset (H-model suffix)
• Insulated steel jacket
• Integrated draft diverter, damper and connector included
• Heavy gauge 1” base insulation
• Step-opening redundant gas valve
• Spark ignition with continuous retry
• User-friendly wiring with 120V J-box
• Circulator – choice of Taco or Grundfos
• Cast iron section assembly
• Resettable blocked vent switch
• Boiler drain valve
• Cast iron supply manifold with safety relief valve tapping

A great boiler, and an even better value

The new X-2 boiler is designed to provide reliable, efficient heat and to exceed the expectation of what a value-priced boiler should be. Equipped with the same cast iron heat exchanger as the IQ Series gas boilers, it provides comparible efficiencies (84% AFUE). The X-2 isn’t a stripped-down boiler...far from it actually. It comes equipped with many standard features found on more expensive boilers. Equipment, such as a Low Water Cut- Off safety device can be built into the X-2 at the factory, saving time and money over having your heating contractor install it as an add-on later.

The “heart” of the matter

A cast iron heat exchanger is at the heart of every X-2 boiler. Crafted at a foundry in Zanesville, Ohio it is comprised of 100% recycled material and designed for years of reliable home comfort. Each cast iron heat exchanger is water and pressure tested prior to assembly in the finished boiler.

Built to last, made in America

When it comes to home heating, every BTU is precious. U.S. Boiler Company understands, and takes energy efficiency seriously. From thick insulated plates and seamless corners in the burner base to the insulated steel jacket, the X-2 is designed to keep heat where it belongs...in the heating system. The boilers themselves are built in Lancaster, PA. Every component is subject to strict standards of quality control and performance verification used throughout the manufacturing process.